Gutter Cleaning - Numatic + CCTV. All work is completed from ground level using the extendable poles.
Persons exposed
Type of assessment
Hazards and control measures
Hazard
• Electric shock from operating mains supply electrically operated tools.
• Electric tools / appliances are PAT tested at prescribed intervals by a qualified electrician.
• Electrical tools etc are not used in wet conditions.
• Electrical tools are “double insulated”.
• Defective equipment is withdrawn from service until repaired or replaced.
• Users inspect equipment prior to using the equipment
Hazard
• Noise induced hearing loss.
• It is unlikely the noise will exceed the permitted limits. However, if required a noise survey will be carried out and the findings implemented.
• Hearing protection is provided if necessary.
Hazard
• Hand / arm vibration from using power tools.
• Exposure to Hand Arm Vibration is minimal due to design of the equipment.
Hazard
• Tripping over trailing cables
• Cables are run in areas with low foot fall.
• If a cable must run across a busy walkway then covers will be used.
• The nearest socket to the work area will be used.
• Electric tools / appliances are PAT tested at prescribed intervals by a qualified electrician.
• Users inspect equipment prior to using the equipment
Hazard
• Injuries to persons in the area the tool is being used e.g. falling equipment
• Appropriate clothing is issued to employee for working outside.
• Waterproof / warm clothing for winter months.
• Sunscreen for hot weather.
Hazard
Not specified
• General Controls
• All equipment is used within their design capabilities
• When not in use equipment is placed in their appropriate storage areas.
• Examinations for signs of safety defects should be conducted prior to and following use.
• Defective equipment should be withdrawn from service until repaired or replaced.
• All employees are shown the correct way to use and assemble the equipment.